![]() Most of the demos I've seen are mainly around RF filter response. After a little research and viewing a few videos it looks kind of cool. Maybe it's scope envy.Īs I'm shopping new scopes the Bode Plot function has been listed on a couple of them. Bandwidth is fine and I've never needed more than two inputs for audio work. It works fine for most of what I do but the screen resolution is limited and the screen is kind of small and these newer scopes seem to do a lot more. So what's happening is that I'm looking to replace my digital scope, a BK 2534. Frequency response measurements are limited to 51 kHz since it requires both channels.Īnd to be honest every time it boots up and goes through its self test routine I keep my fingers crossed. ![]() In particular the lowest frequency bins can be very erratic with low resolution unless you really limit the span and stay away from the bottom bins. I've had this box for years and I have a pretty good grasp of what it can and can't do. ![]() It also does a fair job of displaying harmonic distribution in its THD mode. I've been using an old HP 35660A to run frequency response plots on amplifiers I've either been repairing or building. I'm looking for some people that have had experience with the Bode Plot function on some of the newer digital oscilloscopes. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |